Please note: While these termination instructions offer a helpful guide, they should always be used alongside current connector system manufacturing instructions for best results.

About the Termination Instructions

These instructions are intended solely for terminating Gore’s Ethernet cables with the plug and socket versions of the Amphenol® µ-Com Connector System. They first detail the tools and materials you’ll need, which include:

  • Needle nose pliers, scalpel, tweezer scissors and hand strippers
  • Cutters and crimpers (M22520/2-01)
  • Positioner (31095)
  • Clamp tool (Tie-Dex® II)
  • Copper foil tape (3M-3313)
  • Braid brush
  • Probe/pick
  • Insertion/extraction tool (DHK 696)

Preparing the cable and parts, terminating the plug connector (Termination A) and socket connector (Termination B), and closing the connectors are all covered thoroughly with easy-to-follow, step-by-step instructions and photos to help you ensure proper termination.

Performing Required Testing

Before closing the connectors, you should perform all required testing. Gore recommends that you complete the following steps at a minimum. You may be required to complete additional testing by local authorities and/or end-users.

  • Verify proper wiring and continuity
  • Check for shorts
  • Verify accurate assembly length

Contact a Gore Representative for More Information or Assistance

Terminating Gore’s aerospace wires and cables properly with connectors ensures high-speed data transmission with optimal signal integrity. These assembly termination instructions should only be used for GORE Aerospace Ethernet Cables with the plug and socket versions of the Amphenol® µ-Com Connector System. To learn more about Gore’s high-speed data cables or to request complimentary samples in 48 hours, contact a Gore representative today.